Clamp on Beam Load Transducer

Quick Links to Information Below

• Clamp on Beam Load Transducer Overview
• Features of the Clamp on Beam Load Transducer
• Ordering Information
• Specifications of the Clamp on Beam Load Transducer

PDF Documents

• Clamp on Beam Load Transducer
• Clamp on Beam Load Transducer - Spanish Version

Clamp on Beam Load Transducer Overview

eP’s beam sensor is the culmination of years of research and testing to create a highly accurate device that can be easily installed by one person. This unit cannot be damaged by pumping unit problems that normally render common rod pump control (RPC) load cells (i.e. pump sticking, floating, or sanding problems, etc.) useless.

In addition, eP’s beam sensor can directly replace RPC load cells, using the same cable assembly. A version is also available that provides both load and position in one compact “easy to install” unit (see ordering information). Internal electronics provide compensation for ambient temperature variations. Lightning protection is a standard feature of this beam sensor. Special aerospace finish and environmental seals make the unit well suited for long-term use in typically harsh oil field environments.

Features of the Clamp on Beam Load Transducer

• Simple installation, with only an allen wrench
  • No required welding
  • No “hot work” permits required
  • FM approved for Class I, II, and III, Division 1 and 2, Groups C through G
• Virtually impervious to variations in temperature
• Replaces RPC load cell (using the same cable)
• Load and position inclinometer available, with only one cable
• On most wells, higher sensitivity than RPC load cell (0- to 3-mV/V) – gives a more detailed card of well condition
• Excellent choice for sticking, floating, or troublesome wells
• Compatible with all eP RPC systems

Ordering Information

Specifications of the Clamp on Beam Load Transducer